Concrete square pile mold

The concrete square pile mold can be used to make concrete square piles. In the process of making, standard and qualified products can be made according to certain use methods, and can be used normally. Before using the mold, it should be checked to see if the surface is smooth and flat. Only if the mold is smooth enough can the surface of the product be smooth enough, with sufficient sealing, the corrosion resistance of the product will not be affected, and the durability can be guaranteed. After the inspection, the sludge on the mold should be cleaned, because the existence of sludge will affect the production speed of the product, and adhesion will occur during demoulding. At the same time, Sludge will also affect the firmness of the product. If the product is not firm enough, it will affect the durability. In the long-term use process, there will be strong wrinkles or cracks, resulting in the need to replace the rainwater inspection well. During installation, screws shall be used to connect various modules of the mold. During connection, attention shall be paid to the tight connection and no joint yard shall be allowed, otherwise, grout leakage may occur during grouting. During grouting, the vibrating rod shall be inserted into the raw material to discharge the gas in it, so as to prevent too much gas from causing many bubbles in the product and insufficient internal firmness, which may also cause the external surface to be not smooth enough and the drainage performance to be reduced, which may lead to the blockage of the concrete square pile.